Assem ly Step 4
iiiiiii
Ignitor Knob
Control Knob | Control Panel |
| Assembly |
Screwdriver
i!
1.Leave the cabinet upside down.
2.Attach the Ignitor Knob and the Control Knob to the control panel as shown. Make
sure the Control Knob properly seats on the keyed shaft.
3.Line up the control panel as shown.
4.The HVR stem must be inserted into the venturi as shown in Figure 1 on the following page.
5.When sliding the control panel into place, make sure the tabs capture the legs as shown in Figure 2 on the following page.
6.Connect the ignitor wire to one
of the prongs on the ignitor as shown in Figure 2 on the following
page.
7.Insert the 2 remaining bolts from Hardware Bag A through the tabs on the Control Panel and thread them into the mounting holes.
8.Firmly tighten all of the bolts and nuts.
9.Carefully turn the smoker upright onto its legs.
