Warranty and Returns | Grizzly G0456 guide

SECTION 7: SERVICE	30
Troubleshooting	30
Aligning Headstock Spindle to Tailstock	32
Replacing or Tightening V-Belt	33
Replacing Motor Brushes	34
Table Tilt	35
Aligning Table	35
Miter Gauge	36
Electrical Components	37
Wiring Diagram	38
Parts Breakdown	39
Parts List	40
WARRANTY AND RETURNS	42

Image 4

Grizzly G0456 owner manual Warranty and Returns

Contents

Model G0456 Variable Speed Wood Lathe Page Table of Contents Warranty and Returns Foreword IntroductionContact Info Machine Data Sheet Identification Safety Safety Instructions for Machinery Always Lock Mobile Bases if Used Before Operating Machinery Additional Safety for Wood Lathes 220V Single-Phase Circuit Requirements SET UP Set Up SafetyItems Needed for Set Up Unpacking Inventory Components Figure Qty InventoryHardware not shown Qty Clean Up Site Considerations Components and Hardware Needed Qty Mounting LatheTo mount the lathe bed To install the sanding table To install the tool restSanding Table Tool Rest To connect a dust collection hose Dust Collection Test RunTo test run the machine Operations Operation Safety Safety KeyControls To position the tailstock along the bed Adjusting Tailstock Adjusting Tool RestTo position the tool rest along the bed To install the centers Installing/Removing Spur CenterTo remove the spur center To install the live center Installing/Removing Live CenterTo remove the live center Selecting Turning Tools Gouge To set up a spindle turning operation Spindle Turning Faceplate Turning To mount your workpiece to the faceplate Changing Speeds Sanding/FinishingTo mount your workpiece to a backing block To change between High and Low speeds Attaching Sandpaper Disc SandingTo attach sandpaper To perform sanding operations Miter Sanding Angle SandingTo perform miter sanding operations To perform angle sanding operations Accessories G1194-3-Jaw ChuckG1082-4-Jaw Chuck G3168-1-1⁄2 x 8 TPI RH Threaded Insert Model H6542 Robert Sorby 8-PC Set G9863-8-PC HSS Lathe Chisel Set Model Grit PSA Sanding Discs 2 pkH1300 H1298 G7984 H2347 H0736 Maintenance Cleaning/Lubricating Service Troubleshooting Wood Lathe Operation To check headstock/tailstock alignment Tools Needed QtyTo align the headstock with the tailstock Replacing or Tightening V-Belt To change the V-belt Replacing Motor Brushes To replace the motor brushes To adjust table tilt Table TiltAligning Table To align the table To adjust miter gauge Miter Gauge Electrical Components Wiring Diagram Parts Breakdown Parts List Description Description Warranty and Returns Page Page