Grizzly G0456 owner manual Table Tilt, Aligning Table, To adjust table tilt, To align the table

Table Tilt

When the table tilt is set to 0˚, the table should be adjusted perpendicular to the sanding disc face.

Tools Needed	Qty
Try-Square or Machinist's Square	..................... 1

To adjust table tilt:

1. Using a try-square or machinist’s square, set one edge on the table surface and the other against the face of the disc as shown in Figure 50. Note: This can be done with the sandpaper installed, although it is somewhat easier to measure if the disc does not have the sandpaper disc installed.

Figure 50. Squaring table to disc.

2.Loosen the lock lever, adjust the table angle square with the disc, and tighten the lock lever.

3.Adjust the indicator line over the 0° mark by loosening/tightening the mounting screw, as shown in Figure 51.

Figure 51. Adjusting table tilt indicator.

G0456 Variable Speed Wood Lathe

Aligning Table

The table must be aligned to the face of the sanding disc so that the sandpaper does not rub against the table.

To align the table:

1.Loosen the table mount bolts (Figure 52) that secure the table to the table support bracket.

Table

Mount

Bolts

Figure 52. Table mount bolts.

-35-