Maintenance, Cleaning/Lubricating | Grizzly G0456 instruction

SECTION 6: MAINTENANCE

Always disconnect power to the machine before performing maintenance. Failure to do this may result in serious person- al injury.

G0456 Variable Speed Wood Lathe

Cleaning/Lubricating

Cleaning the Model G0456 is relatively easy. Vacuum excess wood chips and sawdust, and wipe off the remaining dust with a dry cloth. If any resin has built up, use a resin dissolving cleaner to remove it. Treat all unpainted cast iron and steel with a non-staining lubricant after cleaning.

Lubricate the unpainted cast iron surfaces on the bed by wiping the table clean after every use— this ensures moisture from wood dust does not remain on bare metal surfaces. We recommend using products such as G96® Gun Treatment, SLIPIT®, or Boeshield® T-9 for lubricating the unpainted cast iron on your machine.

-29-

Image 31

Grizzly G0456 owner manual Maintenance, Cleaning/Lubricating

Contents

Model G0456 Variable Speed Wood Lathe Page Table of Contents Warranty and Returns Foreword IntroductionContact Info Machine Data Sheet Identification Safety Instructions for Machinery Safety Always Lock Mobile Bases if Used Before Operating Machinery Additional Safety for Wood Lathes Circuit Requirements 220V Single-Phase Unpacking SET UPSet Up Safety Items Needed for Set Up Inventory Components Figure Qty InventoryHardware not shown Qty Site Considerations Clean Up Components and Hardware Needed Qty Mounting LatheTo mount the lathe bed Tool Rest To install the sanding tableTo install the tool rest Sanding Table To connect a dust collection hose Dust Collection Test RunTo test run the machine Operations Operation Safety Safety KeyControls To position the tailstock along the bed Adjusting Tailstock Adjusting Tool RestTo position the tool rest along the bed To install the centers Installing/Removing Spur CenterTo remove the spur center To install the live center Installing/Removing Live CenterTo remove the live center Gouge Selecting Turning Tools Spindle Turning To set up a spindle turning operation To mount your workpiece to the faceplate Faceplate Turning To change between High and Low speeds Changing SpeedsSanding/Finishing To mount your workpiece to a backing block To perform sanding operations Attaching SandpaperDisc Sanding To attach sandpaper To perform angle sanding operations Miter SandingAngle Sanding To perform miter sanding operations G3168-1-1⁄2 x 8 TPI RH Threaded Insert AccessoriesG1194-3-Jaw Chuck G1082-4-Jaw Chuck G9863-8-PC HSS Lathe Chisel Set Model H6542 Robert Sorby 8-PC Set Model Grit PSA Sanding Discs 2 pkH1300 H1298 G7984 H2347 H0736 Cleaning/Lubricating Maintenance Troubleshooting Service Wood Lathe Operation To check headstock/tailstock alignment Tools Needed QtyTo align the headstock with the tailstock To change the V-belt Replacing or Tightening V-Belt To replace the motor brushes Replacing Motor Brushes To align the table To adjust table tiltTable Tilt Aligning Table Miter Gauge To adjust miter gauge Electrical Components Wiring Diagram Parts Breakdown Description Parts List Description Warranty and Returns Page Page