Grizzly G0527 Table Movement Adjusting Feed Rate, Controls for adjusting Table height

Table Movement Adjusting Feed Rate

The table height can be adjusted either manually or by power assist.

Manual Adjustment—Manual adjustments are made by turning the handwheel located under the front of the infeed table. The thickness measure- ment is displayed on the digital readout.

Power Assist—Press the TABLE UP or TABLE DOWN key on the control panel shown in Figure 12. The digital display reading changes as the table moves up and down.

23 0

5 6

8 9

Figure 12. Controls for adjusting

the table height.

NOTICE

The thickness gauge is pre-calibrated from the factory; however, correct calibration should be verified by using the instructions on page 27.

The feed belt motor and gear assembly (Figure 13) controls the speed of the feed belt. The Model G0527 features feed belt speeds of 16.4, 23, and 32.8 FPM.

32.8

16.4

23

Figure 13. Table drive chain and sprockets.

To change feed belt speed:

1.Disconnect the sander from the power source!

2.Remove the cap screw that secures the feed belt motor cover.

3.Loosen the motor mount bolts so that the motor will slide up enough to get the chain off the sprockets.

4.Determine which speed is best for your appli- cation and place the chain accordingly.

5. Tighten the motor mount bolts loosened in step 3.

6.Replace the motor cover and secure it with the cap screw removed in step 2.

G0527 18" Wide Belt Sander -21-