Starting the machine:
1.Wear safety glasses at all times when run- ning the machine!
2.Connect the machine to the power source.
3.Press the TABLE UP and TABLE DOWN keys. The table should go up and down smoothly.
4.Press the FEED BELT START and FEED BELT STOP buttons. The feed belt should start, run and stop smoothly.
5.Press the SANDING BELT START and SANDING BELT STOP buttons. The sanding belt should start, run and stop smoothly.
The machine should run smoothly, with little or no vibration or rubbing noises. Strange or unnatural noises should be investigated and corrected before operating the machine further.
If the machine seems to be running correctly, let it run for a short time to ensure that the moving parts are working properly with no excessive vibration. DO NOT operate the machine if prob- lems cannot be corrected.
If you cannot locate the source of unusual noises, feel free to contact our Service Department at (570)
Recommended
Adjustments
For your convenience, the adjustments listed below have been performed at the factory and require no further adjustment. However, because of the many variables involved with shipping, we recommend that you read through Section 8: Service Adjustments on page 27 and verify that the adjustments are correct.
Recommended adjustment checklist:
•Calibration
•Feed Belt Tension
•Feed Belt Tracking
•Oscillation Timing
•Oscillation Speed
•Pressure Rollers
•Table Parallelism
•
•Air System
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
G0527 18" Wide Belt Sander | ||||||
