Grizzly G0588/G0591 instruction manual Extension Tables, To install the extension tables

Extension Tables

Components and Hardware Needed:	Qty
Large Extension Wing	1
Small Extension Wing	1
Support Leg	1
Hex Bolt M10-1.5 x 45	1
Flat Washer 10mm	1
Lock Washer 10mm	1
Cap Screws M8-1.25 x 30	4
Set Screws M8-1.25 x 20	2
Lock Washers 8mm	4
Flat Washers 8mm	4
To install the extension tables:

1.Thread the set screws into the lower holes in the small extension table. Make sure the set screws do not stick out from the mating surface.

Note: Do not completely tighten the bolts in the following steps until the tables are lev- eled.

2.Attach the small extension table with two M8- 1.25 x 30 cap screws, lock washers, and flat washers as shown in Figure 19.

Note: Get assistance positioning the tables and holding them in place while installing.

Figure 19. Small extension table attachment.

3.Attach the large extension table with the remaining M8-1.25 x 30 cap screws, lock washers, and flat washers.

-22-

4.Attach the support leg (Figure 20) to the table with the M10-1.5 x 45 hex bolt, a lock washer, and a flat washer.

Figure 20. Support leg installation.

5.Check the table surfaces with a straightedge as shown in Figure 21.

Figure 21. Checking with a straightedge.

6.Adjust the set screws under the small exten- sion table to align the surface with the main table surface.

7.Use the hex bolt in the support leg to level the surface of the large extension table.

8.Tighten all of the cap screws securing the tables.

G0588/G0591 12" Sliding Table Saws