Grizzly G0588/G0591 Crosscutting full size panels, Fence to Blade on Page 48 if necessary

Crosscutting full size panels:		4.	Load the workpiece onto the table saw. The
			set up should look similar to Figure 58.
1. Install the crosscut fence in the forward
	mounting points shown in Figure 60 and lock	5.	Once all the necessary safety precautions
	it in place.
			have been taken, perform the cutting opera-
			tion.
		Crosscutting using the rip fence as a
		cut-off gauge:
	Rear Mounting	1.	Install the crosscut fence in the rear mount-
	Points		ing points shown in Figure 60 and lock it in
	Forward		place.
	Mounting Points	2.	Check to make sure the fence is at 90˚ and
			adjust it as described in Squaring Crosscut
			Fence to Blade on Page 48 if necessary.
		3.	Position the rip fence for the desired width.
	Figure 60. Crosscut fence mounting points.	4.	Load the workpiece onto the table saw. The
2.			set up should look similar to Figure 59.
	Check to make sure the fence is at 90˚ and	5.
	adjust it as described in Squaring Crosscut		Slide the leading end of the rip fence behind
	Fence to Blade on Page 48 if necessary.		the back edge of the blade as shown in
3.			Figure 61.
	Set either flip stop to the desired width-of-
	cut.
4.	Load the workpiece onto the table saw. The
	set up should look similar to Figure 57.

5.Once all the necessary safety precautions have been taken, perform the cutting opera- tion.

Crosscutting smaller panels:

1.Install the crosscut fence in the rear mount- ing points shown in Figure 60 and lock it in place.

2.Check to make sure the fence is at 90˚ and adjust it as described in Squaring Crosscut Fence to Blade on Page 48 if necessary.

3.Set either flip stop to the desired width-of- cut.

Figure 61. Correct rip fence position when using it as a cut-off gauge.

6.Take all the necessary safety precautions, then perform the cutting operation.

-38- G0588/G0591 12" Sliding Table Saws