Assembly

To attach the elevation handle assembly:

1.Align the flat portion inside the handle bore with the flat portion on the shaft.

2.Insert the handle assembly on the elevation shaft.

3.Thread the M5-.8 x 25mm cap screw with the lock washer through the handle and into the shaft to secure the handle in place, as shown in Figure 5. DO NOT over-tighten.

Cap Screw

Handle

& Washer

 

Figure 5. Attaching handle.

Test Run

Once the assembly is complete, test run your machine to make sure it runs properly and is ready for regular operation.

The test run consists of verifying the following:

1)The motor powers up and runs correctly, and

2)the safety disabling mechanism on the switch works correctly.

If, during the test run, you cannot easily locate the source of an unusual noise or vibration, stop using the machine immediately, then review Troubleshooting on Page 25.

If you still cannot remedy a problem, contact our Tech Support at (570) 546-9663 for assistance.

-12-

To test run the machine:

1.Connect the machine to the power source.

2.Make sure you have read the safety instruc- tions at the beginning of the manual and that the machine is setup properly.

3.Make sure all tools and objects used during setup are cleared away from the machine.

4.Verify that the machine is operating correctly by turning the machine ON.

—When operating correctly, the machine runs smoothly with little or no vibration or rubbing noises.

—Investigate and correct strange or unusual noises or vibrations before operating the machine further. Always disconnect the machine from power when investigating or correcting potential problems.

5.Turn the machine OFF.

6.Remove the switch disabling key, as shown in Figure 6.

Figure 6. Removing switch key from paddle

switch.

7.Try to start the machine with the paddle switch.

—If the machine does not start, the switch disabling feature is working as designed.

—If the machine starts, immediately stop the machine. The switch disabling feature is not working correctly. This safety feature must work properly before proceeding with regular operations. Call Tech Support for help.

G0663 12½" Planer

Page 14
Image 14
Grizzly G0663 owner manual Assembly, Test Run, To attach the elevation handle assembly, To test run the machine