HP 6200 Pro H3D90USABA, 6200 PRO QN084AW#ABA, 6200 Pro A2W44UT#ABA manual Power Switch Assembly

Power Switch Assembly

Description	Spare part number
Power switch/LED assembly	646820-001

The power switch assembly is mounted to the front of the chassis and removed by pulling it away from the chassis.

1.Prepare the computer for disassembly (Preparation for Disassembly on page 76).

2.Remove the computer access panel (Computer Access Panel on page 77).

3.Remove the computer access panel (Front Bezel on page 78).

4.Disconnect the cable from the black system board connector labeled PB/LED.

5.Press downward on the tabs (1) at the top of the assembly.

6.Rotate the top of the assembly downward (2), and then pull it away from the chassis while threading the wires through the hole in the front of the chassis.

Figure 6-41Removing the power switch assembly

To install the power switch assembly, reverse the removal procedure.

112 Chapter 6 Removal and Replacement Procedures – Convertible Minitower (CMT) Chassis