HP 8200 A2W54UT#ABA manual Power-On, Password Options, Smart Cover some, Device Security

Table 2-4Computer Setup—Security (continued)

Power-On	Allows you to set and enable a power-on password. The power-on password prompt appears after
Password	a power cycle. If the user does not enter the correct power-on password, the unit will not boot.
	NOTE: This selection will only appear when at least one drive that supports the DriveLock feature
	is attached to the system.
	See the Desktop Management Guide for more information.
Password Options	Allows you to enable/disable:
(This selection appears	●	Lock Legacy Resources (appears if a setup password is set). Default is enabled.
only if a power-on	●	Setup Browse Mode (appears if a setup password is set) (allows viewing, but not changing,
password or setup
password is set.)		the F10 Setup Options without entering setup password). Default is enabled.
	● Password prompt on F9, F11, & F12 (allows access to menus without entering setup
		password). Default is enabled.
	● Network Server Mode (appears if a power-on password is set). Default is disabled.
	See the Desktop Management Guide for more information.
Smart Cover (some	Allows you to:
models)	● Lock/unlock the Cover Lock.
	● Set the Cover Removal Sensor to Disable/Notify User/Setup Password.
	NOTE: Notify User alerts the user that the sensor has detected that the cover has been removed.
	Setup Password requires that the setup password be entered to boot the computer if the sensor
	detects that the cover has been removed.
	This feature is supported on some models only. See the Desktop Management Guide for more
	information.
Device Security	Allows you to set Device Available/Device Hidden (default is Device Available) for:
	● Embedded security device (some models)
	●	System audio
	● Serial ports (some models)
	● Parallel port (some models)
	●	Network controller
		NOTE: You must disable AMT before trying to hide the network controller.
	●	SATA0
	●	SATA1
	●	SATA2 (some models)
	●	SATA3 (some models)
	●	SATA4 (some models)

Computer Setup (F10) Utilities 11