HP 8200 A2W54UT#ABA, 6200 Pro H3D90USABA, 6200 PRO QN084AW#ABA, 6200 Pro A2W44UT#ABA manual

Installing a 3.5-inch SATA Hard Drive into an Internal Drive Bay

NOTE: The system does not support Parallel ATA (PATA) hard drives.

Before you remove the old hard drive, be sure to back up the data from the old hard drive so that you can transfer the data to the new hard drive.

To install a hard drive in a 3.5-inch internal drive bay:

1.Prepare the computer for disassembly (Preparation for Disassembly on page 76).

2.Remove the computer access panel (Computer Access Panel on page 77).

3.Install four 6-32 isolation mounting guide screws, two on each side of the drive. Figure 6-29Installing the Hard Drive Guide Screws

NOTE: The hard drive uses 6-32 isolation mounting guide screws. Eight extra guide screws are installed on the hard drive bracket under the access panel. The HP-supplied isolation mounting guide screws are silver and blue.

If you are replacing a drive, transfer the guides screws from the old drive to the new one.

Drives 103