HP 6200 Pro A2W44UT#ABA, 6200 Pro H3D90USABA, 6200 PRO QN084AW#ABA, 8200 A2W54UT#ABA manual

6.Remove the 10 screws (1) that secure the system board to the chassis.

7.Slide the system board toward the front of the computer so that the connectors loosen from the rear of the chassis, and then lift the system board out of the computer (2).

Figure 6-49Removing the system board

NOTE: When replacing the system board, you must also change the chassis serial number in the BIOS.

CAUTION: Before reinstalling the fan sink you must clean the top of the processor and the bottom of the heat sink with an alcohol pad supplied in the spares kit. After the alcohol has evaporated, apply thermal grease to the top of the processor from the syringe supplied in the spares kit.

122 Chapter 6 Removal and Replacement Procedures – Convertible Minitower (CMT) Chassis