HP 6200 Pro A2W44UT#ABA, 6200 Pro H3D90USABA, 6200 PRO QN084AW#ABA manual 3Drive Positions

10.Connect external cables to the installed card, if needed. Connect internal cables to the system board, if needed.

11.Replace the computer access panel.

12.Reconnect the power cord and turn on the computer.

13.Lock any security devices that were disengaged when the access panel was removed.

14.Reconfigure the computer, if necessary.

Drive Positions

Figure 7-13Drive Positions

Table 7-3Drive Positions

1Two 5.25-inch drive bays for optional drives (optical drives shown)

2One 3.5-inch drive bay for optional drive (media card reader shown)

3Secondary 3.5-inch internal hard drive bay for optional hard drive

4Primary 3.5-inch internal hard drive bay

NOTE: The drive configuration on your computer may be different than the drive configuration shown above.

To verify the type and size of the storage devices installed in the computer, run Computer Setup.

142 Chapter 7 Removal and Replacement Procedures – Microtower (MT) Chassis