HP 6200 Pro H3D90USABA, 6200 PRO QN084AW#ABA, 6200 Pro A2W44UT#ABA, 8200 A2W54UT#ABA manual

11.Lift up the front of the system board, and then pull the system board forward, up, and out of the chassis (2).

Figure 8-39Removing the system board

To install the system board, reverse the removal procedure.

NOTE: When replacing the system board, you must also change the chassis serial number in the BIOS.

CAUTION: Before reinstalling the heat sink you must clean the top of the processor and the bottom of

the heat sink with an alcohol pad supplied in the spares kit. After the alcohol has evaporated, apply thermal grease to the top of the processor from the syringe supplied in the spares kit.

CAUTION: When reconnecting the cables it is important that they be positioned so they do not interfere with the rotation of the drive cage or power supply.

208 Chapter 8 Removal and Replacement Procedures – Small Form Factor (SFF) Chassis