HP 6200 Pro H3D90USABA, 6200 PRO QN084AW#ABA, 6200 Pro A2W44UT#ABA, 8200 A2W54UT#ABA manual

7.Connect the power and data cables to the drive as indicated in the following illustrations.

a.If you are installing an optical drive, connect the power cable and data cable to the back of the drive.

NOTE: The power cable for the optical drives is a two-headed cable that is routed from the system board to the rear of the optical drive bays.

b.If your are installing a media card reader, connect the USB cable to the USB system board connector labeled MEDIA.

Figure 7-19Connecting the Media Card Reader USB Cable

8.If installing a new drive, connect the opposite end of the data cable to the appropriate system board connector.

NOTE: If you are installing a new SATA optical drive, connect the data cable for the first optical drive to the white SATA connector on the system board labeled SATA2. Connect the data cable for a second optical drive to the black SATA connector on the system board labeled ESATA. If the ESATA connector is already populated, connect the second optical drive to the light blue connector (8200 Elite models) or the white connector (6200 Pro models) labeled SATA1.

Refer to System Board Connections on page 132 for an illustration of the system board drive connectors.

9.Replace the front bezel and computer access panel.

10.Reconnect the power cord and any external devices, then turn on the computer.

11.Lock any security devices that were disengaged when the access panel was removed.

148 Chapter 7 Removal and Replacement Procedures – Microtower (MT) Chassis