HP 6200 Pro H3D90USABA, 6200 PRO QN084AW#ABA, 6200 Pro A2W44UT#ABA, 8200 A2W54UT#ABA manual

6.Gently slide the drive into the uppermost available bay until it snaps into place. When the drive is properly inserted, the drivelock will secure it. Repeat this step for each drive.

Figure 6-51Installing a Drive in the Desktop Configuration

CAUTION: The bottom 5.25-inch drive bay has a shorter depth than the upper two bays. The bottom bay supports a half-height drive or other device that is no more than 14.5 cm (5.7 inches) in depth. Do not try to force a larger drive, such as an optical drive, into the bottom bay. This could cause damage to the drive and the system board. The use of unnecessary force when installing any drive into the drive bay may result in damage to the drive.

7.Reconnect all power and data cables to the drives in the 5.25-inch drive bays.

8.Remove the bezel subpanel as described in Bezel Blanks on page 80.

CAUTION: Hold the subpanel straight when you pull it away from the front bezel. Pulling the subpanel away at an angle could damage the pins that align it within the front bezel.

9.Reposition the bezel blanks within the subpanel in the proper orientation for the desktop configuration.

124 Chapter 6 Removal and Replacement Procedures – Convertible Minitower (CMT) Chassis