HP 6200 Pro H3D90USABA, 6200 PRO QN084AW#ABA, 8200 A2W54UT#ABA Removing a Drive from a Drive Bay

Removing a Drive from a Drive Bay

CAUTION: All removable media should be taken out of a drive before removing the drive from the computer.

1.Prepare the computer for disassembly (Preparation for Disassembly on page 76).

2.Remove the computer access panel (Computer Access Panel on page 77).

3.Remove the front bezel (Front Bezel on page 78).

4.Disconnect the drive cables, as indicated in the following illustrations:

CAUTION: When removing the cables, pull the tab or connector instead of the cable itself to avoid damaging the cable.

●If you are removing an optical drive, disconnect the power cable and data cable from the back of the drive.

●If you are removing a media card reader, disconnect the USB cable from the system board. Figure 6-14Disconnecting the Media Card Reader USB Cable

●If you are removing a hard drive, disconnect the power cable and data cable from the back of the drive.

92 Chapter 6 Removal and Replacement Procedures – Convertible Minitower (CMT) Chassis