Table 2-3Computer Setup—Storage (continued)

DPS Self-Test

Allows you to execute self-tests on ATA hard drives capable of performing the Drive Protection

 

System (DPS) self-tests.

 

NOTE: This selection will only appear when at least one drive capable of performing the DPS self-

 

tests is attached to the system.

 

 

Boot Order

Allows you to:

 

●

Specify the order in which EFI boot sources (such as a internal hard drive, USB hard drive,

 

 

USB optical drive, or internal optical drive) are checked for a bootable operating system

 

 

image. Each device on the list may be individually excluded from or included for consideration

 

 

as a bootable operating system source.

 

 

EFI boot sources always have precedence over legacy boot sources.

 

●

Specify the order in which legacy boot sources (such as a network interface card, internal

 

 

hard drive, USB optical drive, or internal optical drive) are checked for a bootable operating

 

 

system image. Each device on the list may be individually excluded from or included for

 

 

consideration as a bootable operating system source.

 

●

Specify the order of attached hard drives. The first hard drive in the order will have priority in

 

 

the boot sequence and will be recognized as drive C (if any devices are attached).

NOTE: You can use F5 to disable individual boot items, as well as disable EFI boot and/or legacy boot.

NOTE: MS-DOS drive lettering assignments may not apply after a non-MS-DOS operating system has started.

Shortcut to Temporarily Override Boot Order

To boot one time from a device other than the default device specified in Boot Order, restart the computer and press Esc (to access the boot menu) and then F9 (Boot Order), or only F9 (skipping the boot menu) when the monitor light turns green. After POST is completed, a list of bootable devices is displayed. Use the arrow keys to select the preferred bootable device and press Enter. The computer then boots from the selected non-default device for this one time.

Computer Setup—Security

NOTE: Support for specific Computer Setup options may vary depending on the hardware configuration.

Table 2-4Computer Setup—Security

OptionDescription

Setup Password Allows you to set and enable a setup (administrator) password.

NOTE: If the setup password is set, it is required to change Computer Setup options, flash the

ROM, and make changes to certain plug and play settings under Windows.

NOTE: This selection will only appear when at least one drive that supports the DriveLock feature is attached to the system.

See the Desktop Management Guide for more information.

10

Chapter 2 Computer Setup (F10) Utility