SECTION 4: OPERATIONS
Operation Overview
The purpose of this overview is to provide the nov- ice machine operator with a basic understanding of how the machine is used during operation, so the machine controls/components discussed later in this manual are easier to understand.
Due to the generic nature of this overview, it is not intended to be an instructional guide. To learn more about specific operations, read this entire manual and seek additional training from expe- rienced machine operators, and do additional research outside of this manual by reading "how- to" books, trade magazines, or websites.
To reduce the risk of serious injury when using this machine, read and understand this entire manual before operating.
Damage to your eyes and lungs could result from using this machine without proper pro- tective gear. Always wear safety glasses and a respirator when operating this machine.
To complete a typical cutting operation, the operator does the following:
1.Examines the workpiece to make sure it is suitable for cutting.
2.Raises the headstock, then closes the downfeed valve.
3.Adjusts the headstock angle for the type of cut, then securely clamps the workpiece in the vise.
4.Adjusts the guides as close as possible to the workpiece without contacting it, and verifies that the blade is properly tensioned.
5.Adjusts the downfeed rate adjust knob for the correct feed rate.
6.Makes sure the workpiece and bandsaw are stable and that there are no obstructions in the way of the cut.
7.Puts on safety glasses.
8.Starts the bandsaw and waits for the blade to reach full speed.
9.Opens the downfeed valve to lower the head and blade into the workpiece, then allows the bandsaw to complete the cut.
10.Once the bandsaw has stopped, raises the head, and removes the workpieces.
NOTICE
If you have never used this type of machine or equipment before, We strongly recom- mend that you read books, review industry trade magazines, or get formal training before beginning any projects. Regardless of the content in this section, Grizzly Industrial will not be held liable for accidents caused by lack of training.
Model G0717 (Mfg. Since 9/10) |
