Belt, To replace the V-belt | Grizzly G0717 manual

V-Belt

If the V-belt may require periodic tightening, espe- cially after the initial break-in period. The V-belt needs to be replaced if it shows any signs of glazing, cracking, or fraying. To tighten the belt, perform the following procedure, omitting Step 4.

To replace the V-belt:

1.UNPLUG THE BANDSAW!

2.Open the belt cover.

3.With one hand, support the weight of the motor. With the other hand, loosen the hex bolt shown in Figure 54. The motor will drop and the V-belt will slacken.

Hex Bolt

Figure 54. Belt tension bolt.

Model G0717 (Mfg. Since 9/10)

4.Remove the V-belt, then install a new belt to the desired pulley combination (refer to Figure 33 for blade speeds).

5.Lift the motor to tension the belt and tighten the hex bolt.

—Check the belt tension. When properly ten- sioned, the belt will deflect approximately 1⁄4", as shown in Figure 55, when pressed with moderate force. Adjust as necessary.

Pulley

Deflection

Pulley

Figure 55. Proper belt tension.

6.Close the belt cover.

-43-

Image 45

Grizzly G0717 owner manual Belt, To replace the V-belt

Contents

Model G0717 Page Table of Contents Introduction Manual Accuracy Contact InfoMachine Description Identification Machine Data Sheet Other Safety Instructions for Machinery Safety Unattended OPERATION. Never leave Safety Instructions for Metal Cutting Bandsaws Availability Power SupplyFull-Load Current Rating Circuit Information Extension Cords Grounding RequirementsMinimum Gauge Size 12 AWG 50 ft Needed for Setup SetupUnpacking Description Qty Item Figure Qty Inventory Cleanup Before cleaning, gather the followingBasic steps for removing rust preventative Site Considerations Lifting & Placing Using Machine MountsMounting Bolting to Concrete Floors To assemble your machine Assembly Mounting belt cover Model G0717 Mfg. Since 9/10 Power Connection Connecting PowerDisconnecting Power Controls Blade on Button Starts the blade Test Run Operation Overview Operations Blade Terminology Blade SelectionBlade Length Model Tooth Type Tooth Set To select the correct blade pitch Blade Pitch TPI To change the blade on the bandsaw Blade Change To tension the blade on the bandsaw Blade Tension Blade Tracking Blade BreakageMost common causes of avoidable blade breakage are Downfeed Blade Care Break-InBlade Care Blade Break-In To change blade speeds Downfeed Pressure Blade Speed Blade Speed Chart Chip Inspection Chart To adjust the rear blade guide arm Vise Blade Guide ArmsTo rapidly change the vise jaw gap Hazard Cutting Fluid To use the cutting fluid system Cutting Fluid System Typical blade brush Blade Brush Operation Tips H9231-Safe Tap Stick, 13 oz Accessories H4978 T20446 H4979 Basic Eye Protection Cleaning MaintenanceSchedule Lubrication Gear box To change the gear oil Service TroubleshootingMotor & Electrical Refer to Feed Rate on Page 29, or Blade Speed Bandsaw Operations To replace the V-belt Belt Wiring Safety Instructions Wiring See Wiring Overview 110 VAC Wiring Diagram Electrical Box 27-1 53-2 66-1 28-1 53-1 72-1 70-1 29-1 52-1 Description Base Parts List PW06M Flat Washer 12MM PB35M Model Bow Motor Mount Plate Saw Bow Parts List PCAP07M CAP Screw M6-1 X Labels Comments Warranty Card BOX BELLINGHAM, WA Grizzly INDUSTRIAL, INC Warranty & Returns Order Hours a DAY