Grizzly G1005Z owner manual Test Run, To test run the machine

5.Thread the handwheel handles into the handwheels and tighten using a 5mm hex wrench.

6.Thread the remaining handwheel handle into the headstock adjustment handle.

Test Run

Once the assembly is complete, test run your machine to make sure it runs properly.

If, during the test run, you cannot easily locate the source of an unusual noise or vibration, stop using the machine immediately, then review the Troubleshooting on Page 27.

If you still cannot remedy a problem, contact our Tech Support at (570) 546-9663 for assistance.

G1005Z Mill/Drill

To test run the machine:

1.Make sure you have read the safety instruc- tions at the beginning of the manual and that the machine is setup properly.

2.Make sure all tools and objects used during set up are cleared away from the machine.

3.Ensure the machine is switched OFF.

4.Connect the machine to the power source.

5.Turn the machine ON.

6.Listen to and watch for abnormal noises or actions. The machine should run smoothly with little or no vibration or rubbing noises.

—Strange or unusual noises should be inves- tigated and corrected before operating the machine further. Always disconnect the machine from power when investigating or correcting potential problems.

-15-