6.Raise or lower the rear of the wing until the wing and table are flush. Tighten the bolt. Further adjustments should be minimal.
7.Check flushness at the front bolt and adjust if necessary.
8.Repeat Steps
9.Now, check the alignment of the table and both wings with a straightedge. The straight- edge should run flat across both wings and the table top. If the straightedge contacts both wings and the table evenly, you are fin- ished with this section. If it does not, contin- ue to Step 10.
10.If the extension wings tilt up or down at the outside edges, remove the wings and shim them with masking tape as shown in Figure 7.
a.If the wings tilt down, stick layers of mask- ing tape under each bolt near the bottom edge of the wing and retighten.
b.If the wing tilts up, apply layers of masking tape above each bolt near the top edge of the wing and retighten. Allow tape to extend above the table surface and trim with a sharp knife after final assembly.
11.Replace the wings and check again.
Guard Support Shaft
1.Disconnect the table saw from the power source.
2.Push the threaded end of the shaft through the hole in the back of the sawand into the rear trunnion bracket (Figure 8).
3.Reach into the table opening and secure the guard support shaft with the hex nut and washer.
4.Slide the guard support over the shaft and tighten the hex bolt.
FIGURE 8. Attaching guard support shaft.
Masking Tape
Figure 7. Using tape to shim for wing alignment.
G5959Z 12" |
