10.Refer to Figures 24 and 25, for shim place- ment. If the distance of A is shorter than B, shim(s) will need to be placed under corners #1 and #2. If the distance of B is shorter than A, shim(s) will need to be placed under cor- ners #3 and #4. Very thin shim stock works well, just make sure they are all the same thickness, and you put an equal number under each of the two corners.
11.Rotate through the bolts, tightening them a little each time until they are all secure.
12.Now recheck the blade to the miter slot at 90¡ and 45¡ by repeating steps
.004" at both 90¡ and 45¡, continue to the ÒMiter GaugeÓ instructions. If the distances are still more than .004", repeat steps
13.Once you feel you have the miter slot adjust- ed to the blade, recheck all measurements and be sure the table mounting bolts are secure. Repeat step 10 in Section 4: Assembly, ÒBlade Guard/Splitter.Ó NoteÑ when removing the table in the future, take note of shim placements for ease of re- assembly.
| ! |
| Blade tilted to 45û |
#1 | #3 |
| Front |
#2 | #4 |
Figure 24. 45¡ blade parallelism.
!
Blade tilted to 45û
#1#3
B
Front
#2#4
Figure 25. 45¡ blade parallelism.
|
|
|
|
|
|
|
|
|
|
|
|
G5959Z 12" | |||
