Fence Rails
1.Disconnect the table saw from the power source.
2.Attach the rear rail (the shorter of the two rails) to the table top using the spacers, hex bolts and lock washers supplied, as shown in Figure 9. Use an adjustable square set to 15Ú32" to measure the rail so it is consistently 15Ú32" below the top of the table.
Figure 9. Rear rail attachment procedure.
3.Attach the front rail to the table top using the hex socket flathead screws as shown in Figure 10. Place an adjustable square on the edge of the table, and adjust the rail so it is consistently 25Ú32" below the top of the table.
4.Attach the square fence tube to the front rail using the hex bolts and lock washers as shown in Figure 11.
5.Attach the fence and slide it across the length of the rails to ensure smooth, accu- rate fence movement.
Figure 11. Attaching fence tube to front rail.
Motor Bracket
1.Disconnect the table saw from the power source.
2.Remove the red motor bracket shown in Figure 12. This bracket is designed to pro- tect the motor assembly during shipping.
