To adjust V-belt tension:

1.Loosen the motor mount bolt.

2.Shift the motor up or down to increase or decrease the V-belt tension. Tighten the motor mount bolt.

3.Check the V-belt tension again. Ensure that the motor pulley and arbor pulley are lined up.

To replace the V-belts:

1.Remove the blade.

2.Adjust the arbor so it is up all the way and in the 90¡ position.

3.Place a board under the motor and loosen the motor mount bolt. Slowly lower the arbor until the motor rests on the board, allowing the belts to be loose on the pulleys.

4.Pull off the old V-belts and replace them with new ones. Have the number from the belt ready when calling the service department for replacements.

5.Raise the arbor and remove the board to adjust the V-belt tension.

6.Tighten the motor mount bolt.

Lubrication

The shielded ball bearings in the motor and throughout the Model G5959Z require no further lubrication during their lifetime. When they do wear out, replacements can be obtained through the Grizzly Parts Department.

Lubricate the areas indicated below every 12 months.

1.Blade angling trunnions. These should be lubricated with 6 or 7 drops of light machine oil.

2.Blade height trunnion. This should also be lubricated with 6 or 7 drops of light machine oil.

3.The two worm gears should be lubricated with an automotive wheel bearing grease. The blade angle worm gear is not shown in

Figure 43.

These points can be reached by removing the table. Check all adjustments when finished lubri- cating.

Figure 43. Lubricate these areas.

G5959Z 12" Left-Tilting Table Saw

-33-

Page 35
Image 35
Grizzly G5959Z instruction manual Lubrication, To adjust V-belt tension, To replace the V-belts