Haier AC12CS1ERA, AC18CS1ERA Remove the intake grill, Floor Console Type 1.Drilling for piping

Installation Procedure

PREPARING INDOOR UNIT INSTALLATION

Remove the intake grill

Open the intake grill and remove the three or four or six screws.

Note:

The main unit can be wired before the indoor unit is installed. Select the most appropriate installation order.

A.FLOOR CONSOLE TYPE 1.Drilling for piping

Select piping and drain directions. The piping and drain can be made in three directions as shown in the Fig.1.

The drain hose can be connected to either the left or right side. (Fig.2)

When the directions are selected, drill a 7 cm dia. hole on the wall so that the hole is tilted downward toward the outdoor for smooth water flow. When the pipe is led out from the rear, make a hole at the position shown in Fig.3.

Intake grill

Fig. 1

rear

right down

Fig. 2

Drain hose (Left side) Drain hose (Right side)

Fig. 3

Wall
	6mm
7cm
Indoor unit	outdoor unit

When installing set to wall, install the accessory wall bracket at the position shown in Fig. 4, and mount the set to it.

2. Installing drain hose

Select whether the drain hose will be connected to the left or right side (Fig.2). Insert the drain hose into the drain pan, then secure the drain hose with a nylon fastener (Fig.5).

Wrap the insulation (drain hose) around the drain hose connection. (Fig.6)

Fig. 4
		99cm	24.5cm
		50cm
				Wall bracket
				Side of set
65.5cm 53cm		6.5cm
	4.5cm	7cm hole		6.5cm
		3.5cm hole
		12.5cm	10cm
Fig. 5		Drain pan

Nylon fastener

Drain hose

Fig. 6 Drain pan

Insulation

(Drain hose)

Drain hose

12