Cleaning and Care
CAUTION:
Before cleaning the air conditioner, be sure to turn it off and disconnect the Power Supply Cord.
Be sure the Intake Grill is installed securely.
When removing and replacing the air filters, be sure not to touch the heat exchanger, or personal injury may result.
Cleaning the Air Filter
1. Open the Intake Grill
Pull out both sides and the center of the Intake Grill.
2. Pull the Air Filters upward to remove them
Push the Air Filter handles away from the Intake Grille in the direction as illustrated, then pull out Air Filters.
3. Clean the Air Filters
Remove the dust from the Air Filters by vacuum cleaner or washing them. After washing, allow the Air Filters to dry thoroughly in an area protected from sunlight.
4. Re-attach the Air Filters to the Intake Grill
(1)The Filters fit onto the inside of the intake Grill.(Figure 1) (2)The bottom edges of the Air Filters should fit into the filter brackets. (Figure 1)
(3)The Air Filters should be pushed down so that their top edges fit under the projections at the top of the Intake Grill. (Figure 2)
5. Close the intake grill
Push in both sides and the center of the Intake Grill.
About 30 mm | Side Panel |
| Hook |
| Notch |
| Arm |
Arm Intake Grill |
|
| Air Filter |
| Bracket |
| Base |
Air Filter | Handle |
(Figure 1) | (Figure 2) |
| |
Filter bracket |
|
Dust can be cleaned from the Air Filter either with a vacuum cleaner, or by washing the filter in a solution of mild detergent and warm water. If you wash the filter, be sure to allow it to dry thoroughly in a shady place before reinstalling.
If dirt is allowed to accumulate on the Air Filter, air flow will be reduced, operating efficiency lowers and noise increases. During periods of normal use, the Air Filters should be cleaned every two weeks.
Operation Tips
Instructions relating to heating are applicable only to "HEAT & COOL TYPE"
Heating Performance
This air conditioner operates on the
Microcomputer-controlled Automatic Defrosting
When using the Heating mode under conditions of low outdoor air temperature high humidity, frost may form on the outdoor unit, resulting in reduced operating performance.
In order to prevent this kind of reduced performance, this unit is equipped with a
8