Installation Procedure
3. Installing brackets
Install the brackets with nuts, washers and spring washers. (Fig.14)
Fig.14A
Spring washer | Bracket | |
Special nut | ||
|
Fig.14B
Bracket (Left) | Bracket (Right) |
4. Installing indoor unit
Reset the hex bolts as shown in Fig.15.
Apply the indoor unit to the brackets. (Fig.16) Now, securely tighten the hex bolts in both sides.
5. Installing the drain hose
Fig.15 | Hex bolt |
| |
Indoor unit | 8 to 13mm |
Fig.16
Bolt Bracket
Indoor unit
Select whether the drain hose will be connected to the left or right side.(Fig.2)
Insert the drain hose into the drain pan, then secure the drain hose with a nylon fastener.(Fig.5) Wrap the insulation (drain hose) around the drain hose connection. (Fig.6)
Be sure to arrange the drain hose correctly so that it is leveled lower than the drain hose connecting port of the indoor unit. (Fig.17)
Fig.17 | Remove the hole cover. |
|
Arrange the drain hose | Drain hose |
| |
lower than this portion |
|
OK | NO |
When drain hose is arranged backward. Secure the drain hose with the VT wire. (Fig.18)
Fig.18
Piping hole
VT wire
Base (Bottom)
VT wire hole
Intake grill
Pass the drain hose through here | Cut the grill | Drain hose |
14
