Haier DWL3025 Water Line, Direct wire method, 3a. Power supply cord method, Helpful Tip

HELPFUL TIP:

Wiring the dishwasher will be easier if you route wire into the cabinet opening from the left side.

3. Direct wire method:

Cut a ¾” (1.9 cm) hole “C” in righthand cabinet side, rear or floor. Optional locations are shown.

Wood Cabinet: Sand hole until smooth.

4.Run wire into house wiring junction box. Use strain relief method provided with junction box. If no strain relief is provided, install a cUL-listed/CSA-certified clamp connector for flexible-type wire. If installing conduit, attach a cUL-listed/CSA-certified conduit connector to junction box.

5. Run other end of wire through cabinet hole. Cable must extend to the left front of cabinet opening. Go to step 6.

6” (15.2 cm)

3a. Power supply cord method:

Cut a 1½” (3.8 cm) hole “D” in right-hand cabinet rear or side. Optional locations are shown.

Wood cabinet: Sand hole until smooth.

4a. Install a mating, three-proung, grounding-type wall receptacle “E” in the cabinet next to the dishwasher opening. Go to step 6.

Water Line

HELPFUL TIP:

Routing the water line through the left side of cabinet opening will make water connection easier.

6.Cut a ½” (1.3 cm) minimum hole “F” in left-hand cabinet

side,rear or floor. Optional locations are shown. (The hole “F” is about 13/5” higher than hole “C” or hole “D”)

11