5.To prevent vibration during operation, route the
water supply line so that it does not touch the dishwasher base, frame or motor. Make sure the water line stays within the shaded area shown on page 7 when the dishwasher is installed in the cabinet. With copper tubing “J” pushed into compression fitting as far as it will go, use an adjustable wrench and tighten compression fitting nut “I” to elbow “L” on water inlet valve.
6.Place Paper towel under elbow. Turn on water supply and check for leaks.
Drain Connection
7. To help minimize vibration noise, route drain hose to avoid contact with motor, door springs, water line, cabinet, flooring or the edge of the hole where it passes through the cabinet.
Do not remove drain loop “N” from side of dishwasher.
8. Place the smaller drain hose clamp “N” onto the small end of the drain hose “O”. Remove the plug from the connector “P”.
9. Push the drain hose into the connector “P” up to the rib “O” on the drain hose.
10. Use pliers to open clamp “N” and slide clamp onto connector “P” between ribs “O” on connector.
23
