1.Grasp sides of dishwasher door and put dishwasher on its back.
2.Remove two screws “A” attaching access panel “B”
and lower panel “C” to dishwasher using a ¼” hex socket,nut driver or Phillips screwdriver. Remove panels and set panels aside on a protective surface. Check that grounding clip “D” is attached to the lower panel.
3.Apply pipe joint compound “E” to 90° elbow fitting
“F” and connect fitting to water inlet valve “G”. Tighten elbow until snug, and be sure that it faces to the rear.
4. Remove terminal box cover “H”. Pull appliance wires “I” through hole in terminal box. Do not untie the knot in the wires.
If you are direct wiring: install a cUL- listed/CSAcertified clamp connector “J” to the terminal box. If using conduit use a
If you are installing a power supply cord kit, do so now and follow kit instructions.
HELPFUL TIP:
Put cardboard under dishwasher until it is installed. The cardboard will help protect floor covering during installation.
15
