Haier DWL3025 installation manual Electrical Shock Hazard, If direct wiring dishwasher

ELECTRICAL

It is the customer’s responsibility:

To assure that the electrical installation is adequate and in conformance will all national and local codes and ordinances.

You must have:

-120-volt, 60Hz, AC-only, 15- or 20-amp., fused electrical supply, and connected to an individual, properly grounded branch circuit.

-Wiring must be 2-wire with ground and rated for 176°F (75°C).

We recommend:

-a time-delay fuse or circuit breaker.

-a separate circuit.

If direct wiring dishwasher:

- Use flexible, armored or non-metallic sheathed, copper wire with grounding wire that meets the wiring requirements for your home and local codes and ordinances.

- Use strain relief method provided with house wiring junction box or install a cUL-listed/CSA-certified clamp connector to the house wiring junction box. If using conduit, use a cUL-listed/CSA-certified conduit connector.

If connecting dishwasher with a power supply cord:

- Use a cUL-listed, 16-gauge, three-conductor power supply cord that meets all local codes and ordinaces. Maximum length of the power supply cord is 6 feet (1.8 m).

-A clamp connector to fit a 7/8” (2.2 cm) diameter hole is required to secure power supply cord to dishwasher terminal box.

- Power supply cord must plug into a mating three-prong, grounded outlet,located in the cabinet next to the dishwasher opening. Outlet must meet all local codes and ordinances.

WARNING

Electrical Shock Hazard

The improper connection of the equipment grounding conductor can result in a risk of electric shock. Check with a qualified electrician if you are in doubt that the appliance is properly grounded.

7