Clear oil
fill hole
Figure 4
5.Look into the hole in the pump hous- ing. If a metal wheel can be seen extending into the hole, SLOWLY pull the starter rope until the hole appears clear, as shown above.
Fill with oil | TOO HIGH |
to here | TOO LOW |
|
Figure 5
6.Wipe the Dipstick off with a clean, dry cloth. Insert the Dipstick into the pump housing and remove it. The oil level should be at least to the lower
(L) notch on the dipstick, but not above the upper (H) notch. Add SAE
7.Thread the Pump Breather Plug back into the pump.
8.Align the arrow on the Dipstick with the arrow on the Plug, insert it, and twist it to secure.
9.Reconnect the spark plug wire.
Checking Fuel Level
Warning! To prevent fire, shut the engine off and wait for it to cool before adding fuel. Do not smoke.
1.Clean the Fuel Filler Cap and the area around it.
2.To check the fuel level, unscrew and remove the Fuel Filler Cap.
3.Mix fuel stabilizer (not included) with 89 octane (or better) unleaded gasoline according to fuel stabilizer directions.
4.Fill the Fuel Tank to about 1 inch under the lip of the gasoline tank with the stabilized unleaded gasoline mixture.
5.Then replace the Fuel Filler Cap.
SKU 67596 | For technical questions, please call | Page 13 |
