Page 16 For technical questions, please call 1-800-444-3353. SKU 67596
Hold the Wand at about a 45° 7.
angle when cleaning; spraying the
surface directly could embed dirt
into the surface (especially with the
high pressure Nozzles). Spray at a
distance of about three to ve feet.
Clean vertical and sloped surfaces •
from the top down.
When cleaning horizontal surfaces, •
occasionally use the stream to clear
the area of excess water.
cautiOn do not allow the Pressure
washer to idle, without the trig-
ger held down, for more than two
minutes. the water will heat up
and damage the Pressure washer.
risK OF Burns!
the pump will also expel very hot
water if allowed to idle too long.
Hold the Trigger down and move 8.
the Wand back and forth slowly
and steadily to pressure wash the
surface. Take special care when
spraying surfaces made of two
different materials (brick and mortar,
for example), to not damage the
softer of the two materials during
pressure washing.
If the surface is streaked or uneven 9.
at the end of a job, switch to a Nozzle
that has a wider spray pattern to
blend the affected area.
When nished; release the Trigger 10.
on the spray handle, turn the engine
power switch “OFF”, turn the water
supply off and then shut off gas
supply to the engine.
Squeeze the Trigger to release 11.
excess pressure.
If Pressure Washer detergent has 12.
been used for the job, run clean
water through the system to eliminate
detergent residue.
To prevent accidents, turn off the 13.
engine and after the engine has
cooled, disconnect its spark plug wire
after use. Drain all water out of the
unit. Clean external parts with clean
cloth, then store the equipment out
of children’s reach according to the
Storage instructions in this manual.