Harbor Freight Tools 95668 operating instructions Hex Nut. See Figure M, Figure J

2.Thread one end of the Draw Bar (121) into the bottom end of the Spindle (105) approximately 10 to 15 turns until tight. (See Figure J.)

3.Insert the Spindle/Draw Bar assembly into the Spindle Housing (110) from the top side of the Work Table (52). (See Figure K.)

4.Thread the tapered Draw Bar Hex Nut (122) onto the end of the Draw Bar (121) under the Work Table (52), making sure the tapered side of the Hex Nut is facing upward. (See Figure L.)

5.Place a wrench (not included) on the top end of the Spindle (105).

6.Using an open-end wrench (not included), tighten the Draw Bar Hex Nut (122) while holding the Spindle (105) securely. DO NOT over-tighten the Draw Bar

Hex Nut. (See Figure M.)

FIGURE J FIGURE K

SPINDLE

(105)

DRAW BAR

(121)

SPINDLE HOUSING (110)

FIGURE L	FIGURE M
	SPINDLE (105)

DRAW BAR HEX NUT

(122)

	DRAW BAR HEX NUT
	(122)
		REV 07j
SKU 95668	For technical questions, please call 1-800-444-3353	PAGE 12