See Figure DD | Harbor Freight Tools 95668 instruction

6.Tighten the Lock Handle (61) to lock the infeed Fence (60) in position.

(See Figure DD.)

		FENCE
	FENCE	(60)
	FENCE	OUTFEED SIDE
	(60)	OUTFEED SIDE
	INFEED SIDE

FIGURE DD

LOCK HANDLE

(61)HAND KNOB

(68)

7.Adjust the outfeed Fence (60) so that it is located as far back from the front of the Work Table (52) as possible. (See Figure DD.)

8.Turn on the Wood Shaper.

9.Using a piece of scrap wood, advance the workpiece 8” into the Cutter and turn off the machine. DO NOT remove the workpiece from the infeed Fence (60).

(See Figure DD.)

10.Once the Cutter has come to a complete stop, adjust the outfeed Fence (60) so that it just touches the newly cut edge of the workpiece. Always follow the direction of feed as shown below. (See Figure EE.)

(GUARD NOT SHOWN FOR CLARITY)

INPUT FEED

DIRECTION OF FEED

OUTPUT FEED

FIGURE EE

11.Check to make sure all Aluminum Fence Lock Handles (61) are tight before proceeding to finish the cut. (See Figure DD.)

SKU 95668

For technical questions, please call 1-800-444-3353

PAGE 21

Page 21

Image 21

Harbor Freight Tools 95668 operating instructions See Figure DD

Contents

Industrial SHAPER/ROUTER For technical questions or replacement parts, please call General Safety Rules Product SpecificationsSave this Manual Work Area Electrical Safety Tool USE and Care Service Specific Safety RulesPage Grounding See 3-Prong Plug and Outlet Prong Plug and Outlet Outlets for 2-Prong PlugSee Outlets for 2-Prong Plug Stand Assembly Assembly InstructionsUnpacking See Figure F See Figure G Optional Table Spacer Installation Installing The Safety Guard Installing The FencesInstalling The Spindle 57, 59. See Figure H Figure J Hex Nut. See Figure M Router Bit Assembly Adjustments InstructionsSee Figures K, L, and M See Figure O See Figure P Fence Alignment57, 59. See Figure Q Table Inserts Belt AdjustmentSee Figure R Screws. See Figure S Cutter Installation Cutter DirectionSee Figure T See Figure Y, next Setting Spindle Height See Figure AA Rub Collars Cutter. See Figure CC Operating Instructions Start Up To Set Up The Wooden Fences For Straight Shaping Figure DD See Figure DD Freehand Shaping To Set Up The Aluminum Fences For Partial Edge Removal Figure HH See Figures HH See Figure JJ Pattern Shaping Please Read the Following Carefully INSPECTION, MAINTENANCE, and Cleaning Problem Possible Reason Possible Solution Troubleshooting Description Parts List Motor Wiring Diagram Assembly Diagram Mission Oaks Blvd. PO Box 6009 Camarillo, CA 93011 800 Limited 1 year / 90 Day warranty