Harbor Freight Tools 95668 Table Inserts, See Figure R, Belt Adjustment, Screws. See Figure S

Table Inserts:

1.Table Inserts (53, 53A) are used to reduce wood chips falling into the machine which could cause flying debris. Using the smallest Table Insert also covers any unused portion of the bit below the surface of the Work Table (52).

(See Figure R.)

2.Position, and snap in the Table Insert (53, 53A) you wish to use. (See Figure R.)

3.Make sure the Table Insert (53, 53A) is seated and flush with the Work Table (52) surface. (See Figure R.)

FIGURE R

Belt Adjustment:

TABLE INSERT

(53, 53A)

WORK TABLE

(52)

1.The Wood Shaper uses a Belt (123) on two Pulleys (113, 127) to compensate for different Belt positions as the Spindle (105) height is adjusted. To adjust the V-Belt:

Loosen the two Hex Head Screws (134). Slide the Motor (129) position to increase or decrease V-Belt (123) tension, so that the Belt is snug with about 1/4” deflection when pressed lightly with your finger. Then, retighten the Hex Head

Screws. (See Figure S.)

FIGURE S

V-BELT (123)

HEX HEAD SCREW

(134)

MOTOR (129)

SKU 95668 For technical questions, please call 1-800-444-3353 PAGE 15