B.Between two Cutters: This set-up has the advantage of making two profile cuts in a single pass. Although there is a Rub Collar (98, 99, 100) beneath a Cutter, this set-up is safer than the previous set-up. Any lifting of the workpiece will still cause the Cutter to make an uneven cut. A second pass will correct the profile on the bottom edge, but the top profile will still have the gouge from lifting the workpiece into the Cutter. (See Figure BB.)
CUTTER
RUB COLLAR
(98, 99, 100)
BETWEEN
CUTTER
FIGURE BB
C.Below the Cutter: This set-up allows the cut to be viewed by the operator. However, it is also the most dangerous. Any slight lifting of the workpiece will cause the Cutter to make too deep of a cut. There is also increased risk of kickback. It is NOT recommended to shape with a Rub Collar below the
Cutter. (See Figure CC.)
NOT RECOMMENDED
RUB COLLAR | | | | CUTTER |
|
| | |
(98, 99, 100) | | | | |
BELOW
FIGURE CC
OPERATING INSTRUCTIONS
1.Use safety equipment. Always wear ANSI-approved safety impact eye goggles. Dust mask or respirator, and hearing protection must be used for appropriate conditions.
SKU 95668 | For technical questions, please call 1-800-444-3353 | PAGE 19 |