5.Prepare the cleaning area. Clear the cleaning area of all objects that are not being cleaned. If any water prone or delicate items cannot be moved, protect them. If detergent is to be used, cover or remove any plants or animals that may be dam- aged by the detergent.
6.Place the pressure washer in an appropriate location. The location should be protected
Operation
Read the entire Important Safety Information section at the beginning of this manual including all text under subheadings therein before set up or use of this product.
To prevent serious injury
from accidental operation:
Turn the Power Switch of the equipment to its “OFF” position before performing any inspection, maintenance, or cleaning procedures.
1.Attach the High Pressure Hose to the Port on the front of the Pressure Washer.
2.Attach the Water Gun into the Water Gun, and press and twist the Wand into the Extension until the Wand locks in place.
NOTE: The Pressure Washer will not pressurize if the Nozzle is not com- pletely assembled. It will not work
from any water from the cleaning area; select a location higher than the cleaning area. The pressure washer’s location should be close enough so that the hose will reach every portion of the job to be done with some slack for movement. Also, select an area with proper access to a dedicated circuit.
properly with only part of the Wand installed.
3.Connect the High Pressure Hose to the Pressure Washer. Make sure all connections are tight. Then, open the water supply valve fully. If leaks occur, shut off water and retighten connections.
4.IMPORTANT! Prior to turning on the Pressure Washer, connect the unit to the water supply. Turn on the water, disengage the safety, and squeeze the Trigger until water flows out of the Water Gun. This removes air from the system and allows the unit to properly perform.
Failure to follow this step can dam- age the Pump.
5.Connect the GFCI plug and test it, as explained on page 10. Turn the Power Switch to the “ON” position.
The motor will briefly run when the switch is first turned on to build up pressure and then go to standby until the trigger is squeezed.
NOTE: The Motor does not run con- tinuously, but only when the Trigger is
SKU 99741 | For technical questions, please call | PAGE 12 | |
Troubleshooting section at end of manual. | |||
|
|
