Inspection, Maintenance,
And Cleaning
Procedures not specifically explained in this manual must be performed only by a qualified technician.
To prevent serious injury
from accidental operation:
Before performing any inspection, maintenance, or cleaning procedures:
a. Turn the Power Switch of the equipment to its “OFF” position.
b. Unplug the equipment from its electrical outlet.
c. Shut off water supply.
d. Safely discharge all residual water pressure.
e. Disconnect water supply hose.
To prevent serious injury from pressure Washer failure:
Do not use damaged equipment. If abnormal noise or vibration occurs, have the problem corrected before further use.
1.Before each use, inspect the general condition of the Pressure Washer. Check for loose screws, misalign- ment or binding of moving parts, damaged electrical wiring, damaged High Pressure Hose, damaged ac- cessories, and any other condition that may affect its safe operation. If abnormal noise or vibration occurs, have the problem corrected before
further use. Do not use damaged equipment.
2.To clean, remove excess water from the Pump by tipping the unit to drain any remaining water from the inlet and outlet fittings. Drain the Deter- gent Dispenser and flush with run- ning water. Use only a clean cloth and mild detergent to clean the body of the Pressure Washer. Do not use solvents.
Do not immerse any part of the tool in liquid. Dry off any remaining water on all parts and fittings.
Remove mineral deposits from the nozzle using a thin, stiff wire. The more minerals that are dissolved in the water (the harder the water) you use, the more often mineral buildup will need to be cleaned out from in- side nozzle.
3.STORAGE: When storing, empty the Pressure Washer of water. Frost will damage the Pressure Washer
if the unit contains water. Store the Pressure Washer in a dry,
4.
WARNING! If the supply cord or plug of this pressure washer is damaged, it must be replaced only by a qualified service technician.
SKU 99741 | For technical questions, please call | PAGE 16 | |
Troubleshooting section at end of manual. | |||
|
|
