Specifications
Electrical Requirements | 120 V / 60 Hz / 13 A |
35 Ft. Long Power Cord | |
Water Pressure | 1,600 PSI |
Flow Rate | 1.6 GPM |
Water Supply Required | |
Hose Length | 19 Ft. |
Unpacking
When unpacking, check to make sure that the item is intact and undamaged. If any parts are missing or broken, please call Harbor Freight Tools at the number shown on the cover of this manual as soon as possible.
Assembly
Read the entire Important Safety Information section at the beginning of this manual including all text under subheadings therein before set up or use of this product.
To prevent serious injury
from accidental operation:
Before performing any inspection, maintenance, or cleaning procedures:
a. Turn the Power Switch of the equipment to its “OFF” position.
b. Unplug the equipment from its electrical outlet.
c. Shut off water supply.
d. Safely discharge all residual water pressure.
e. Disconnect water supply hose.
Note: For additional information regarding the parts listed in the following pages, refer to the Assembly Diagram near the end of this manual.
1.Check the Inlet Strainer for any block- age, including packaging debris. The Pressure Washer may be shipped with a plastic plug in the Inlet.
2.Position the rear of the Handle above the rear of the Pressure Washer body. Connect the Suction Tube from the top of the Pressure Washer body to the connector on the bottom of the Detergent Bottle in the Handle. Make sure that the Suction tube does not bend or get pinched during assembly. Lower the Handle onto the Pres- sure Washer Body. Then secure the Handle to the Pressure Washer body, using the Screws provided.
3.Insert the Spray Wand into the Wa- ter Gun, and twist the Wand into the Extension until the Wand locks in place. Pull the Wand to make certain it is secure.
4.Attach the High Pressure Hose to the Outlet Port on the front of the Pres- sure Washer.
5.Attach the female part of the Quick Connector Set to the Supply Port on the back of the Pressure Washer. At- tach the male part of the Quick Con- nector Set to a
SKU 99741 | For technical questions, please call | PAGE 9 | |
Troubleshooting section at end of manual. | |||
|
|