Now that you have installed your system components and completed at least a basic configuration of your receiver, you are ready to begin enjoying your home theater system.
OPERATION
the Master Power Switch. When the Master Power Switch is turned off, any settings you have programmed, including system configuration and preset radio stations, will be preserved for up to four weeks.
Turning On the AVR 147
Gently press the Master Power Switch until the word OFF is no longer visible. The Power Indicator above the two power switches should light up in amber. This indicates that the AVR is in Standby mode and is ready to be turned on. Normally, you may leave the Master Power Switch in the ON position, even when the receiver is not being used. See Figure 55.
Figure 55 – Power Switches
There are several ways in which the AVR 147 may be turned on:
a)Press the Standby/On Switch on the front panel. See Figure 55.
b)Press the Source Select Button on the front panel. See Figure 56.
Figure 56 – Source Select Button
c)Using the remote, press any one of these buttons: AVR, DVD/CD, TAPE/The Bridge, HDMI 1/HDMI 2, VID1, VID2, VID3, XM, AM/FM or 6CH. See Figure 57.
Figure 57 – AVR and Input Selectors
NOTE: Any time you press one of the remote’s Input Selectors (i.e., DVD/CD, TAPE/The Bridge, HDMI 1/HDMI 2, VID1, VID2 or VID3), the remote will switch modes so that it will only transmit the codes programmed to operate that device. In order to con- trol the receiver, you will need to press the AVR Button to return the remote to AVR mode.
To turn the receiver off, press either the Standby/On Switch on the
front panel, or press the AVR Button and the OFF Button on the remote. Unless the receiver will not be used for an extended period of time (for example, if you will be on vacation), it is not necessary to turn off
Sleep Timer
You may program the AVR to play for up to 90 minutes and then turn off automatically using the sleep timer.
Press the Sleep Button on the remote, and the time until
Figure 58 – Sleep Button
When the sleep timer has been set, the
If you press the Sleep Button after the timer has been set, the remaining time until
Volume Control
The volume may be adjusted either by turning the knob on the front panel (clockwise to increase volume or counterclockwise to decrease volume), or by pressing the Volume Control Buttons on the remote. See Figure 59. The volume is displayed as a negative number of decibels (dB) below the 0dB reference point, and may be changed in 0.5dB increments.
Unlike the volume controls on some other products, 0dB is the maximum volume for the AVR 147. Although it’s physically possible to turn the volume to a higher level, doing so may damage your hearing and your speakers. For certain more dynamic audio materials, even 0dB may be too high, allowing for damage to equipment.
Figure 59 – Volume Controls
The AVR 147 is designed to reproduce audio with a minimum amount of distortion, which may lead you to think that your hearing and the equipment can handle higher volumes. We urge caution with regard to volume levels.
33