7
gasket
fig 3
thermostat
Large blower
fig 4
Feeder
Beginassemblyby slidingthe pusherblockwiththe adjusterrod from the front throughthe slot shown in fig.1.
Be sure the pusher blockisturned with the bolt hole to
Blowers
feed indicatorside.
Next, hold pusher blockin the most rearward posi- tionand slidethe adjuster tube over the adjuster rod untilit bottomsout on the pusher block. Thread the adjuster over the adjuster rod. Thread wingnut on the end of the adjuster rod.
Make sure the gasket is in place on the feeder
Control Box
openingonthe rear of the unit, as shown in fig3.Insert the stoker into the openingin the rear ofthe unit. Boltfast and tighten with (2) 5/16 X 1 1/4 bolts.
Installthesmaller of the two blowerson the bottom of the feeder by slidingit into the bracket as far as it will go. Installrestricter plate on blower as shown below in Fig. 4.
Slide the larger blower into place on the bottom rear
Cleanout Scraper
Install scraper as shown below with locking nut on each side of the scraper. Tighten nuts when in the rear most position to assure alignment. Cycle rod in and out to clean unit.
lock nut
scraper
Restricter Plate
Control Box
Small blower
DO NOT BURN WET COAL
