hoppersupport
slotted holes
Grate insert
fig 5
Grate angle
Grate holder
fig 6
8
Hopper
Install hopper support on top rear of stoker.
Note that bolt holes in hopper support are slotted for adjust-
| ment. Insert small end of hopper into the hopper slot on the feeder |
| as shown. Push top of hopper under the hopper support, causing |
| the slot on the bottom side of the support to hook onto the hopper. |
| The hopper support will spring up slightly for the hopper to go |
| under. If you have difficulty getting the hopper under, adjustment |
| may be necessary. Use slotted holes shown at left. Now the feed |
| motor cover can be installed. |
| Grate |
| The grate is composed of four pieces:the grate holder, (2) |
. | grate inserts, and grate angle. The grate angle is bolted to the |
grate holder with (2) 3/8 X 1 1/4 bolts. Before installing the grate | |
| holder, 3/8" round gasket must be checked in the groove on the |
| botton side of the grate holder, as shown in fig. 7. Check to be sure |
| the gasket has not been damaged. |
| The grate holder must be installed through the top door |
| opening after the feeder has been installed. |
| Locate the flange at the rear of the grate holder into the slot |
| on the feeder as shown below. Bolt the front end down with the |
| 1/4 x 20 Allen bolt and nut provided. The rear end will be locked |
| in place by the flange. Before tightening the bolt be sure the grate |
| holder is back as far as possible and centered side to side on the |
| feeder opening. |
| Install grate inserts as shown at left. Divide the spaces |
| between the inserts equally and be sure they are not tight. The |
| spaces are needed for expansion. |
| firebricks |
fig 7
GasketIMPORTANT
Be sure the grate holder is centered and back as far as possible.
Install firebricks as Shown
DO NOT BURN WET COAL
