Maintenance

Combustion

Blower Cover

Blower Cover

Latch

Fig 26

 

Heat Exchanger Fins

Scraper

Flue

Outlet

Blower

Wheel

Blower Cover

Latch

Fig 27

Scraping the burn pot:

Whenever adding fuel to the hopper, take the time and scrape the grate surface of the burnpot, using the scraper tool provided. This can be done while a fire is burning. Wearing heat resistant gloves, open the firebox door. Scrape any accumulated ashes from in front of the fire, into the ash pan. Now, scrape under the fire, in a downward direction, to loosen any carbon deposits. Do not scrape the fire out of the pot. Whatever you loosen will be pushed out with the flow of new fuel into the pot. (Fig.33)

Removing Ashes:

After approximately 1 ton of pellets has been burned, it will be necessary to empty the ash pan.

Ashes should be placed in a metal container with a tight fitting lid. The closed container of ashes should be placed on a noncombustible floor or on the ground, well away from all com- bustible materials, pending final disposal. If ashes are disposed of by burial in soil or other- wise locally dispersed, they should be retained in the closed container until all cinders have thoroughly cooled.

It is recommended that the stove is cold and shut down when removing the ash pan.

1.Lift the latch handle to open the ash door and remove the ash pan. Use ash pan handle to carry and dispose of ashes.

2.Slide the ash pan back into the stove and latch the door by pushing down on the latch handle when closed.

Cleaning:

The stove should be shut-down and thoroughly cleaned after each ton of pellets consumed. The cleaner the stove, the more efficient it will be.

Note: Fuel with higher ash and/or moisture content will require more frequent cleanings.

1.Shut down the stove and disconnect power cord to insure that all motors are stopped.

2.Clean heat exchanger with scraper as shown in fig 27.

3.Brush or scrape the inside of the stove to remove fly ash.

4.Scrape burnpot with flat end of scraper provided with the stove. Inspect the holes on the burnpot surface. See Fig. 33.

5.Open burn pot clean-out. Clean fly ash from burn pot and replace cover.

P61A Pellet Stove 23

Page 23
Image 23
Harman Stove Company P61A manual Scraping the burn pot, Removing Ashes, Cleaning