OPTIONS
Side Heat Shields
Side heat shields are available to reduce the clearance to combustible materials.
Part
Hopper Extension -Part #1-00-08636
The hopper extension allows you to put more pellet fuel in the hopper which extends the burn time on one load of pellets. The hopper extension adds 70 pounds to the existing hopper capacity, allowing you to load 140 pounds of pellets at one time. The extension seals to the unit hopper with three latches. Some models will require a knockout be removed from the unit hopper prior to installing the extension.
Direct Vent Wall Passthrough Kit
You may choose to use the optional Direct Vent Wall Passthrough Kit (part
Decorative Slate Options
The decorative slate tiles measure 11.938" x 5.938". The tile/slate frame is not necessary to hold the tile in place on the stove. There are 4 decorative slate choices. See dealer for samples.
The Brushed Stainless deer cutout, pictured below, is another option available. This cutout reveals the color of the stove through the cut out shapes.
frame
5.938"
tile/slate
On the rear of the stove hopper there is a
hole to fasten the hopper extension into place. On some units, this hole will need to be opened.You will notice a small uncut area on rear of the knockout. Push downward with a screwdriver or like tool until the knockout is rotated as far back to the inside of the hopper as possible. This will allow the swell latch of the hopper extension to fully expand to the bottom side of the hole for a proper seal.
11.938"
P61A Pellet Stove 31
