Hawking Technology HNC720G Troubleshooting, Status LED, Condition LED Color, Reset and Restore

A. Troubleshooting

Status LED

After powering up, the network camera performs a self-diagnostic to detect any hardware defects. The following table lists the LED patterns in general. In case of any fatal errors, the LED will blink in a pattern other than those below.

Condition	LED Color
During self-diagnostic after power on	Blinking in interchanged green and red
Ethernet signal is lost	Red LED is blinking until Ethernet is detected
Before network is setup	Steady green until IP address is confirmed
After network is setup	Blinks green every second
Any hardware failure	Other patterns

Reset and Restore

Restoring the factory defaults will erase any previous settings. Reset or restore the system after power on.

On the left side of the camera (if facing it), there is a button hidden in the pinhole, as shown in the picture. It is used to reset the system or restore the factory default settings. Sometimes resetting the system sets the system back to its normal state. If the system problems remain after reset, restore the factory settings and install again.

RESET: Insert a fine pen tip, paper clip, or similar object end to click on the button.

RESTORE:

1.Insert a fine pen tip or paper clip and hold the button down.

2.Wait for the self-diagnostic to run twice.

3.Withdraw the pen tip, paper clip, or similar object as soon as the second self-diagnostic starts.

44