Operating the Hayter Mowers SST38/ST42: Leveling Cutterdeck Guide | Pitney Bowes Spark

1.21

OPERATING THE TRACTOR

1.21

CUTTERDECK LEVEL SETTING

WARNING: PREVENT ACCIDENTS - Remove the ignition key and disconnect the spark plug lead before making any adjustments.

To level the cutterdeck:

Ensure that the tractor is on a firm and level surface.

Ensure that the parking brake is engaged.

Check that tyre pressures are within prescribed limits.

Ensure that all four cutterdeck anti-scalp wheels are in their highest position.

Lift the plastic cover at the base of the height of cut notches to reveal the deck levelling notch

Move the height of cut lever into the deck levelling notch.

Loosen the primary drive belt to the deck by releasing it from the drive ten- sioner pulley.

Loosen the left and right wing nuts at the rear and ensure that the four anti- scalp wheels are firmly in contact with the ground. Shake the cutterdeck briskly and briefly in order to ensure that any slackness is removed from the cutterdeck lift linkages. Re-tighten both the left and right wing nuts.

Replace the primary drive belt, ensuring that the tensioner pulley is in position.

Select the desired height of cut and relocate the deck levelling notch cover.

Mow for a short distance. If the height of cut is not level, repeat the cutter- deck levelling procedure.

150005MA010302A

Image 21

Hayter Mowers SST38/ST42 specifications Cutterdeck Level Setting, To level the cutterdeck

Contents

ST38/ST42 Page Be Alert CONTENTS1.4 CONTENTS1.5 Safety Precautions TrainingPreparation Operation Safety Precautions Health and Safety at Work Act Maintenance and Storage Decal Caution Hands and Feet Part No DecalsDecal General Warning Part No MU44x6815 Decal Drawbar Warning Part No MU44x6138 Decal Transaxle Bypass Lever Part No Decal Level Position Part No MU44x6456Decal Height of Cut Part No MU44x6279 Decal Powered Sweeper Collector Part No Decal Serial NumberGuard Rear Flap Part No EC Declaration of Conformity EC Conformity InformationEC Declaration of Conformity Vibration Information EC Declaration of Incorporation EC Declaration of Incorporation Introduction Introduction Specifications Detail SpecificationsEngine Weights and Dimensions WeightRecommended Lubricants Safety Notice Operating the TractorOperator Controls Parking Brake Before Starting the Engine Seat Position Height of CUT SettingHeadlights Cutterblade Control To level the cutterdeck Cutterdeck Level Setting Choke Control Throttle ControlTravel Ignition KEY Fuel Filler CAP Engine OIL Filler CAPTransaxle Bypass Lever Starting and Stopping the Engine Operator Safety System Sweeper Drive Switch Sweeper Working Height SettingEmptying the Sweeper Collector Sweeper Collector Lift Lever ATTACHING/DETACHING the Sweeper CollectorAttaching the sweeper collector Detaching the sweeper collector Maintenance Maintenance Engine Engine OIL Age which will not be covered by the warrantyOIL Filter Do not overfill Filling the fuel tank Fuel and CarburationFuel Filter Combustion and Cooling Air Battery Spark PlugElectrical Tyres and Wheels Removing a front wheelRemoving a rear wheel Lubrication Cutterdeck Replacing Primary Drive BeltReplacing the Secondary Drive Belt MAINTENANCE1.36 Cutterdeck RemovalCutterdeck Attachment Replacement of the Primary Drive Belt Powered Sweeper CollectorReplacement of the Brush Drive Belt Replacement of the Bristle Sections Grass Cutting Faults Grass Cutting Faults Trouble Shooting Trouble Shooting Trouble Shooting Trouble Shooting Electrical Circuit Diagram Parts No Description