MAINTENANCE1.36, Cutterdeck Removal | Hayter Mowers SST38/ST42

1.36

CUTTERDECK

MAINTENANCE1.36

Continued.

Cutterdeck Removal:

- Refer to the ‘Cutterdeck Lever Setting’ procedure and move the height of cut lever to the deck levelling position.

- Remove the R-clips and washers from the rear suspension brackets.

- Remove the R-clips and washers from the rear lift links.

- Disconnect the extension spring from the chassis.

- Remove the R-clip from the hanger rod. Push the hanger rod through and then withdraw from between the hanger brackets. Allow the front suspen- sion bracket to hinge forward and lay on the ground.

- Remove the primary drive belt from the elective clutch output pulley.

- Pull the cutterdeck assembly away from beneath the tractor.

Cutterdeck Attachment:

-Follow the cutterdeck removal procedure in reverse order to install the cutterdeck.

-Ensure that the primary drive belt is correctly routed and located.

-Follow the ‘Cutterdeck Level Setting’ procedure to ensure correct set-up and operation.

150005MA010302A

Page 36

Image 36

Hayter Mowers SST38/ST42 specifications MAINTENANCE1.36, Cutterdeck Removal, Cutterdeck Attachment

Contents

ST38/ST42 Page Be Alert CONTENTS1.4 CONTENTS1.5 Safety Precautions TrainingPreparation Operation Safety Precautions Maintenance and Storage Health and Safety at Work Act Decals Decal Caution Hands and Feet Part NoDecal General Warning Part No MU44x6815 Decal Drawbar Warning Part No MU44x6138 Decal Transaxle Bypass Lever Part No Decal Level Position Part No MU44x6456Decal Height of Cut Part No MU44x6279 Decal Powered Sweeper Collector Part No Decal Serial NumberGuard Rear Flap Part No EC Conformity Information EC Declaration of ConformityEC Declaration of Conformity Vibration Information EC Declaration of Incorporation EC Declaration of Incorporation Introduction Introduction Specifications Detail SpecificationsEngine Weights and Dimensions WeightRecommended Lubricants Safety Notice Operating the TractorOperator Controls Before Starting the Engine Parking Brake Height of CUT Setting Seat PositionHeadlights Cutterblade Control Cutterdeck Level Setting To level the cutterdeck Throttle Control Choke ControlTravel Ignition KEY Fuel Filler CAP Engine OIL Filler CAPTransaxle Bypass Lever Operator Safety System Starting and Stopping the Engine Sweeper Drive Switch Sweeper Working Height SettingEmptying the Sweeper Collector Sweeper Collector Lift Lever ATTACHING/DETACHING the Sweeper CollectorAttaching the sweeper collector Detaching the sweeper collector Maintenance Maintenance Engine Age which will not be covered by the warranty Engine OILOIL Filter Do not overfill Fuel and Carburation Filling the fuel tankFuel Filter Combustion and Cooling Air Battery Spark PlugElectrical Tyres and Wheels Removing a front wheelRemoving a rear wheel Lubrication Cutterdeck Replacing Primary Drive BeltReplacing the Secondary Drive Belt MAINTENANCE1.36 Cutterdeck RemovalCutterdeck Attachment Powered Sweeper Collector Replacement of the Primary Drive BeltReplacement of the Brush Drive Belt Replacement of the Bristle Sections Grass Cutting Faults Grass Cutting Faults Trouble Shooting Trouble Shooting Trouble Shooting Trouble Shooting Electrical Circuit Diagram Description Parts No